Introduction:
This guide addresses common issues related to tape not cutting. Follow the solutions provided below to resolve these issues and ensure optimal tape-cutting performance.
Related Article:
Tapehead Troubleshooting Table:
| Problem | Description | Possible Cause | Corrective Action |
| Blade Covered with Residue | Residue on the blade affecting cutting performance. | Accumulated residue on the blade. | Clean the blade with a rag soaked in oil. |
| Dull Blade | Blade has lost its sharp cutting edge. | Blade has become dull over time. | Replace the blade with a new one. |
| Knife Harness Arm Not Snapping | Knife harness arm is not engaging as intended. | Lack of lubrication, worn springs, or interference. | 1. Add grease or oil at the knife harness pivot.<br> 2. Lubricate or replace springs.<br> 3. Identify and correct interference.<br> 4. Perform repairs if needed. |
| Tension from Mandrel Too Loose | Insufficient tension in the mandrel affecting cutting. | Mandrel tension is too loose. | Increase mandrel tension by turning the washer clockwise. |
Follow these solutions systematically to troubleshoot tape cutting issues effectively on your BestPack machine's tapehead.
Comments
0 comments
Article is closed for comments.