Introduction

This troubleshooting guide addresses a noise issue related to the side belts. If you are experiencing unusual sounds, follow the steps below to identify the cause and implement corrective actions.

Possible Cause and Corrective Action

Detailed Steps:

1. Check for Obstructions on Side Belts:
   1. • Remove the cover to inspect the side belts for any obstructions.
      • If obstructions are found, remove them and adjust the tension on the side belts if necessary.
      • Place the cover back on and test to see if the noise is no longer present.
2. Inspect Motor and Bearing:
   1. • If the noise persists after removing obstructions, turn off the machine and remove the belt from the side drive.
      • Turn on the machine without the belt and observe if the noise is still present.
      • If the noise persists, proceed to motor inspection. If not, the issue may be with the bearing.
3. Motor Inspection:
   1. • Remove the motor by taking off the 4 screws under the motor to detach it from the mounting bracket.
      • Turn on the machine with the motor removed and observe if the noise is still present.
      • If the noise continues, the problem is with the motor, and it needs to be replaced.
4. Bearing Replacement:
   1. • If the noise stops after removing the motor, the issue is with the bearing.
      • Replace the bearing to resolve the noise issue.

Additional Tips:

• Regularly inspect and clean the side belts to prevent obstructions.
• Periodically check the tension of the side belts to ensure proper operation.
• Perform routine maintenance to prolong the life of the motor and bearings.

By following these troubleshooting steps, you can identify and address the noise issue with the side belts effectively.