Introduction

This troubleshooting guide addresses the issue of an ARX machine not indexing properly, where the indexing goes up and down too fast, causing boxes not to stop as expected. Follow the corrective action below to resolve this issue and ensure proper indexing.

Issue Description

• Symptom: The indexing of the ARX machine is going up and down too fast, and boxes are not stopping as they should.

Possible Causes and Corrective Actions

Detailed Steps:

1. Access the Control Box:
   • Locate the control box of the ARX machine.
2. Open the Control Box Cover:
   • Depending on the model, open the cover of the control box to access the internal components.
3. Locate the Timer Setting:
   • Inside the control box, find the timer setting responsible for controlling the indexing speed.
4. Adjust the Timer to 30:
   • Carefully adjust the timer setting to 30. This setting ensures that the indexer rollers stay down long enough for proper carton spacing.
5. Close the Control Box Cover:
   • After adjusting the timer, securely close the cover of the control box.
6. Inspect for Mechanical Obstructions:
   • Examine the indexing mechanism for any mechanical obstructions that may hinder proper operation. Remove any obstructions found.
7. Check for Electrical or Sensor Issues:
   • Inspect the electrical components and sensors for any issues. Repair or replace as necessary.
8. Test the Machine:
   • Run a test cycle to ensure that the indexing speed is now appropriate, and boxes are stopping as expected.

Additional Tips:

• Periodically check and calibrate the timer setting to maintain optimal indexing performance.

By following these troubleshooting steps and adjusting the timer setting to 30, you can effectively resolve the issue of the ARX machine indexing too fast, ensuring proper carton spacing and preventing boxes from moving through the machine simultaneously.

If you encounter challenges during the troubleshooting process, please don't hesitate to reach out to our support team for further assistance.